Argo 2011 ver.02 6 2011
SERVICE
ENGINEER
Password needed. Service Centre authorized access only
MANUFACTURER
Password needed. Manufacturer authorized access only.
WARNING: AFTER 10 ATTEMPTS TO ACCESS THE “
MAINTENANCE
” OR
“
MANUFACTURER
” MENU WITHOUT TYPING IN THE PASSWORD, OR EVERY TIME THE
WRONG PASSWORD IS TYPED, THE MENU WILL BE BLOCKED. “
PASSWORD BLOCKED
”
will be displayed. To unblock the menu, contact the Authorized Service Centre or the
manufacturer.
LANGUAGE
ITALIAN
To confirm language
To exit
ENGLISH
FRENCH
GERMAN
PORTUGU
ESE
This menu allows the setting of the language (see table). Languages may be different
according to the country of destination.
9. COMPULSORY
1. Use only tap water:
2. Never add additives to water.
3. Empty the boiler once a week, making sure the boiler pressure is not over 0 BAR
(fig.2H). For carrying out this operation, turn the exhaust tap slowly: we advise
you to wear gauntlets against possible burns.
4. Never leave hot iron on board.
5. Connect ARGO to suitable protected outlet.
6. After ironing is over, switch ARGO off and close the water; remember to open the
water before switching on the machine again (for ARGO connected to the water
system).
7. Always keep children away from ARGO, both when it is on and off.
8. Make sure that during the cold season tubes connecting ARGO to water supply do
not freeze.
10. IRONING OPERATION
1. Run the iron on the garments, pressing both the red steam button (fig. 4) and the
suction pedal at regular intervals (fig. 1). In order to dry the garments, we advise
to keep the foot on the suction pedal a bit longer.
2. For delicate, black and blue garments, we advise you to use an anti-sheen shoe.
3. During the ironing operation, always put the iron on its iron rest and pay attention
to the position of the cables: if they twine or get in touch with ironing board, they
might cause short circuits.
4. For dry ironing it is possible to adjust the thermostat (fig. 3) on different positions
according to the type of fabric (look at garment label).
5. On the other hand, for steam ironing you should adjust the thermostat on “cotton”
position (this one is good for all kinds of fabric).
To Next Page
