Vulcano 13 2016
10. INTERVENTIONS AND SMALL REPAIRS
1. Replace the cover (Prontotop) every 400 hrs. or maximum 6 months. Replace it
also if the vacuum of the board in unsatisfactory or if stains appear on it. This
operation must be carried out with the machine switched off and cold. Stains may
appear if too much steam is used or if vacuum function is not used enough (in this
case reduce steam flow and use more vacuum). N.B.: the padding can be washed
1 or 2 times.
2. Empty the boiler every 2-3 times you use the machine.
3. Replace the gasket of the safety valve plug every 1200 hrs. of lighting or
maximum 2 years (use only original gaskets).
4. Replace the electric wire when it is damaged. The wire is supplied by the
manufacturer or authorized service centres.
11. COMPULSORY PERIODICAL MAINTENANCE
(To be carried out exclusively by assistance centres or by the manufacturer)
It is recommended to replace:
1. the internal safety valve every 2100 hrs. of ironing or maximum 3 years;
2. the internal thermostat every 2100 hrs. of ironing or maximum 3 years;
3. steam tube and iron cable once they seem damaged (fig. 3);
4. the safety valve plug every 2500 hrs. of ironing or maximum 3 years (fig.1).
It is recommended also to clean the boiler from limestone every 2500 hrs. of ironing
or maximum 3 years.
12. ELECTRICAL RISKS
The following situations are considered dangerous for the operator:
1. earth protector switch is activated when turning on the machine;
2. using ironing board mod. VULCANO during thunderstorms;
3. using ironing board mod. VULCANO without proper protection for feet (without
shoes
4. damaged electrical wires;
5. when the electric wire or pedal wire touch hot parts of the machine;
6. iron overheating or loss of water from the iron (fig. 3);
7. washing or cleaning the iron using water (fig. 3);
8. loss of water from the machine;
9. filling the boiler when the machine is switched on.
13. MECHANICAL RISKS
The following situations are considered dangerous for the operator:
1. using ironing board mod. VULCANO for different purposes other than ironing;
2. replacing the gasket of the safety valve plug with non-original gaskets.
To Next Page
Loading...