MNL- 0345
Page 2 Section 1 Base Edition
While every effort is made to ensure the accuracy of the information contained in this manual, Bauer
Compressors, Inc. will not, under any circumstances be held accountable for any inaccuracies or the con-
sequences thereof.
1.1.2 How to Use the Replacement Parts List
• The use of repair parts other than those included in the Bauer Replacement Parts Lists may create
unsafe conditions over which Bauer has no control. Such unsafe conditions can lead to accidents
that may be life-threatening, cause substantial bodily injury, and/or result in damage to the equip-
ment. Therefore, BAUER Compressors, Inc. can bear no responsibility for equipment in which
non-approved repair parts are installed.
• A lozenge ◊ in the Item Number column indicates the part number for a complete assembly.
• a dagger (†) in the Qty column with or without an ellipis (…) in the Part Number column means
the part is illustrated for assembly purposes only and is not available for sale as an individual
component. This part can be obtained by ordering the complete assembly.
• AR in the Qty column means that the item is cut or manufactured to the size which the customer
specifies.
• A dash (—) in the Item Number column indicates that there is more than one part number appli-
cable to the preceding Item Number.
When placing an order for spare parts, please provide the following information to ensure delivery of the
correct parts.
Model Number Date of Manufacture
Serial Number Quantity required
Part Number Part Description
Example: Junior-E3; manufactured 1998; Serial number 32165; requiring 2 reed valves, p/n N04860.
The model number, date of manufacture and serial number can be found of the compressor unit identifi-
cation plate on the compressor unit’s frame.
Figure 1-1 Compressor Unit Identification Plate
BAUER
COMPRESSORS
BAUER COMPRESSORS, INC.
NORFOLK, VIRGINIA U.S.A
LBL-004
MODEL NO.
BLOCK NO.
CAPACITY
CFM
CHG. RATE
CFM
MOTOR HP
SPEED
RPM
SERIAL NO.
PRESSURE
PSIG
VOLTS
PH
HZ AMPS
DATE OF MANUFACTURE