MNL- 0345
Page 72 Section 4 Base Edition
SECTION 4: PURIFICATION SYSTEMS
4.1 General
The purpose of all BAUER breathing air purification systems is to remove oil, water, taste and odor from
the compressed air stream before final delivery. For this reason BAUER purification systems are installed
immediately before the compressed air delivery point.
4.1.1 System Configurations
BAUER compressor units are available with various purifications systems either as standard features or
factory installed options. The purification systems that apply to the models listed in this manual are found
in the Purification System Applicability in Section 1.4.
4.1.2 General Purification System Procedures
1. Keep an accurate record of operating hours to ensure exact attention to maintenance intervals
2. Change all cartridges before reactivating a compressor unit that has been out of service more than
three months. Leave cartridges in the unit as long as it is out of service.
3. While out of service keep all condensate drain valves closed. Maintain a pressure of 700 to 1,100 psi
(50 to 80 bar) within the system to prevent moisture from entering the compressor and purification
system.
Number and Type of Cartridges Processing Capacity
Title Dryer Purification Securus
Other
a
a. TX = Triplex
®
combined dryer and purifier, 5,000 pst maximum service pressure: CO = Carbon Monoxide conversion
in cubic ft. (ft.)
3
P0 Purification System … … … TX 3,200
P1 Purification System … 1 … … 15,000
P2 Purification System … 1 … … 40,000
P2 with Securus
®
… … 1 … 67,000
P4 Purification System 1 1 … … 60,000
P5 Purification System 1 1 … … 90,000
P5 with Securus
®
1 … 1 … 150, 000
P10 Purification System 2 1 … 140,000
P10 with Securus
®
2 … 1 … 230,000
P12 Purification System
b
b. P12 and P14 are only available with the Securus
®
Moisture Monitoring System.
1 1 CO 420, 000
P14 Purification System
b
2 1 CO 650,000
To Next Page
Loading...
