Page 8 For technical questions, please call 1-888-866-5797. Item 64288
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Release the Trigger and unplug the tool from its electrical outlet
before adjusting the tool or installing accessories.
Adjusting the Auxiliary Handle
The Auxiliary Handle can be placed in a variety of positions.
To adjust the Auxiliary Handle, turn the Handle
counterclockwise to loosen the band. Slide the Handle
to the desired position then turn the Handle clockwise to
secure it in place.
Using the Depth Gauge
The Depth Gauge can be positioned on either
side or on the top of the Rotary Hammer. The
body of the Hammer will interfere with the Depth
Gauge if the Handle is in the bottom position.
1. Turn the Lock Knob to open the Depth Gauge
Slot and slide the Depth Gauge through the
Depth Gauge Slot on the Auxiliary Handle.
2. Position the Depth Gauge as needed, then turn
the Lock Knob to secure the Depth Gauge in
place.
Note: the Drilling depth is the distance from the
tip of the drill bit to the tip of the Depth Gauge.
Adjusting the Functions
Adjust the Drill Switch and Hammer Switch before using the Rotary Hammer. To adjust the Drill Switch, press
the Release Button on the Drill Switch and rotate the Switch until it clicks in place at one of the two positions. To
adjust the Hammer Switch, rotate the Switch until it is horizontal, pointed toward the right or left side of the tool.
NOTICE: Move the Switches only when the Motor is stopped.
Attempting to move the Switches while the Motor is engaged
will result in abrupt bit rotation and can cause property damage.
NOTICE: When moving the Switches, make sure they
click into the desired position. If not actively engaged, a
Switch could slip out of position resulting in tool damage.
To Drill: Rotate the Drill Switch to the Drill ON setting.
Rotate the Hammer Switch to the Hammer OFF Setting.
The Rotary Hammer will revolve when powered.
To Hammer/Drill: Rotate the Drill Switch to the Drill ON setting.
Rotate the Hammer Switch to the Hammer ON setting. The
Rotary Hammer will revolve and hammer when powered.
To Chisel: Rotate the Drill Switch to the Drill OFF setting.
Rotate the Hammer Switch to the Hammer ON setting.
The Rotary Hammer will hammer when powered.
Band Bracket
Auxiliary Handle
Depth Gauge SlotLock Knob
Drilling
Depth
Depth Gauge
Drill Bit
Drill Off
Drill Switch
Drill On
Release
Button
Hammer
On
Hammer
Off
Hammer
Switch
SAFETY OPERATION MAINTENANCESETUP
To Next Page
Loading...
