Page 10 For technical questions, please call 1-888-866-5797. Item 56792
Functions
Auxiliary
Handle
Speed
Control
Trigger
Trigger
Lock
Backing
Pad
Indicator
Light
Spindle
Lock
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Installing a Threaded Accessory
1. The accessory MUST be:
• rated to at least Auxiliary Handle.
• no larger than 7″ (180mm) in diameter.
• fitted with a threaded opening of 5/8″ - 11.
• undamaged.
• a hook and loop sanding disc, polishing bonnet
or foam pad (sold separately) and backing pad.
2. Press Spindle Lock button to
prevent Spindle from turning.
3. Unthread Backing Pad. Thread disc
accessory firmly onto Spindle.
4. Release Spindle Lock button.
Workpiece and Work Area Set Up
1. Designate a work area that is clean and well-lit.
The work area must not allow access by children
or pets to prevent distraction and injury.
2. Route the power cord along a safe route
to reach the work area without creating a
tripping hazard or exposing the power cord to
possible damage. The power cord must
reach the work area with enough extra length
to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects, such
as utility lines or foreign objects, nearby that
will present a hazard while working.
5. You must use personal safety equipment including,
but not limited to, ANSI-approved eye and hearing
protection, as well as heavy-duty work gloves.
SAFETY OPERATION MAINTENANCESETUP
To Next Page
Loading...
