Page 9For technical questions, please call 1-888-866-5797.Item 56792
Specifications
Electrical Rating 120VAC / 60Hz / 12A
Speed 600 - 3500/min
Spindle 5/8″ - 11
Max. Accessory Diameter 7″ (180mm)
Setup - Before Use:
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
Note: For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
ASSEMBLY
Installing the Auxiliary Handle
TO PREVENT SERIOUS INJURY:
Do not operate this tool with one hand only or without the Auxiliary Handle properly installed.
1. Unplug power cord.
2. The Auxiliary Handle may be installed in one of
two positions, on either side of the Gear Housing.
3. Using the included Hex Key (52), connect
the Auxiliary Handle to the tool with
two M10 x 20 Screws (51). Tighten
securely before beginning work.
Screw
(51)
Hex Key
(52)
Auxiliary
Handle
SAFETYOPERATIONMAINTENANCE SETUP
To Next Page
Loading...
