Page 9For technical questions, please call 1-888-866-5797.Item 56367
SAFETYOPERATIONMAINTENANCE SETUP
Tool Changing
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
1. Press Polishing Pad (sold separately)
onto hook and loop on Backing Pad.
2. To remove, pull Polishing Pad off
hook and loop on Backing Pad.
Setting and Testing
1. Ensure Polishing Pad is correctly
mounted on Backing Pad.
2. Plug in tool.
3. Set Speed Switch to highest speed.
4. Press the Trigger and test run tool
for at least 30 seconds.
5. If abnormal noise or vibration occurs, have
the problem corrected before further use.
To Next Page
Loading...
