Page 11For technical questions, please call 1-888-866-5797.Item 58862
SAFETYOPERATIONMAINTENANCE SETUP
General Operating Instructions
1. Make sure that the Switch is in the off-position,
then plug in the tool.
2. Insert Safety Key into Switch.
3. Make sure nothing is contacting the Sanding
Disc or Belt, then turn on the Switch.
4. When using the Disc Sander, only use the LEFT
side of the Sanding Disc (as you face it) to sand.
The Sanding Disc turns counterclockwise and
using the right side could cause kickback.
5. Use two hands and hold workpiece securely
against the table at all times. Press the
workpiece against the disc to start sanding.
Keep the workpiece moving for a better finish.
6. After use, turn off the tool, remove the
Safety Key from the Switch, and disconnect
from the power supply. Clean and store
the tool indoors out of children's reach.
Bevel Sanding
1. Loosen the two Locking Handles.
2. Tilt table to desire angle using the bevel gauge.
3. Tighten the Locking Handles.
Dust Collection
1. Connect dust hose (not included) to Dust Port.
2. Connect opposite end of hose to
dust collection system.
Note: A dust port adapter may be needed
depending on the inlet size of your hose.
To Next Page
Loading...
