Page 5For technical questions, please call 1-888-866-5797.Item 58862
SAFETYOPERATIONMAINTENANCE SETUP
Sander Safety Warnings
For Your Own Safety Read Instruction
Manual Before Operating Sander
1. Wear eye protection.
2. Support workpiece with worktable.
3. Maintain 1/16 inch maximum clearance
between table and sanding disc.
4. Avoid kickback by sanding in accordance
with the directional arrows.
5. The worktable is the surface mounted close
to the sanding surface that the operator rests
the workpiece against to prevent it from being
pulled into the machine. For safety, it must be
adjusted very close to the sanding surface.
6. Sand only on the downward moving surface
of the disc - sanding on the upward moving
surface may result in the workpiece being
thrown up and towards the operator.
7. Remove Safety Key when the Switch is
turned off. Do not leave the Safety Key in
the Switch when the tool is not in use.
8. DO NOT OPERATE WITH ANY GUARD
DISABLED, DAMAGED, OR REMOVED. Moving
guards must move freely and close instantly.
9. The use of accessories or attachments not
recommended by the manufacturer may
result in a risk of injury to persons.
10. When servicing use only identical replacement parts.
11. Only use safety equipment that has been approved
by an appropriate standards agency. Unapproved
safety equipment may not provide adequate
protection. Eye protection must be ANSI-approved
and breathing protection must be NIOSH-approved
for the specific hazards in the work area.
12. Stay alert, watch what you are doing and use
common sense when operating a power tool.
Do not use a power tool while you are tired or
under the influence of drugs, alcohol or medication.
A moment of inattention while operating power
tools may result in serious personal injury.
13. Industrial applications must follow OSHA guidelines.
14. Maintain labels and nameplates on the tool.
These carry important safety information.
If unreadable or missing, contact
Harbor Freight Tools for a replacement.
15. Avoid unintentional starting.
Prepare to begin work before turning on the tool.
16. People with pacemakers should consult their
physician(s) before use. Electromagnetic fields in
close proximity to heart pacemaker could cause
pacemaker interference or pacemaker failure.
17. Use for sanding wood, plastic and
non-ferrous metals only.
18. The warnings, precautions, and instructions
discussed in this instruction manual cannot cover all
possible conditions and situations that may occur.
It must be understood by the operator that
common sense and caution are factors
which cannot be built into this product,
but must be supplied by the operator.
To Next Page
Loading...
