Page 11<&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1Item 58162
?@<6AQRS6;@ACRED@CEA6E@ET6 ?6AFS
C8#*($"83%,%W"$
T&77*$%E'$
?/"897*%G&4Z
T@FACREe When changing a bit immediately
after use, be careful not to touch the bit. It may
be very hot from use, possibly causing injury.
Allow the bit time to cool before handling it.
1. Depress the Spindle Lock.
Rotate collet until shaft is
engaged by the lock.
2. Loosen the Collet Nut by turning
it counterclockwise, using
the Wrench provided.
3. To remove a bit: Pull the bit straight out
of the Collet once the Collet Nut is loose.
To insert a bit: Insert the shank end of the
bit into the Collet once the Collet Nut is loose.
ERA6- Do not force a wrong sized bit into the
collet, and do not modify a mismatched collet or
bit. ?*Y*(*%/*(#&8,7%&(%/(&/*($>%9,5,3*%5,>%
(*#'7$%2(&5%'#"83%5"#5,$4.*9%4&77*$#%&(%+"$#1
4. Tighten Collet Nut securely using the
provided wrench. Ensure that the spindle
lock is released before turning on the tool.
C8#$,77"83%?."*79
The housing cap is interchangeable
with the shield attachment.
1. Remove the housing cap by
turning counterclockwise.
B&'#"83%T,/%
2. Install the shield attachment by
turning lock nut clockwise. Reposition
Shield by turning it left or right.
G&4Z%E'$
?."*79
E&$*- When installing or removing, use only
hand pressure and tighten firmly by hand.
Do not overtighten, as this may damage the part.
U&(Z/"*4*%,89%U&(Z%@(*,%?*$%F/
1. Designate a work area that is clean
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
2. Secure loose workpieces using
a vise or clamps (not included)
to prevent movement while working.
3. There must not be objects,
such as utility lines, nearby that will
present a hazard while working.
To Next Page
Loading...
