Bauer 2327E-B - Functions; Guard Setup; Dust Extraction Setup

Page 8 For technical questions, please call 1-888-866-5797. Item 58871
SAFETY OPERATION MAINTENANCESETUP
5. The Work Stop (84) fits across the top of the
Sanding Belt to prevent the workpiece from moving
to the rear when sanding.
6. Align two holes on the Work Stop with two Holes
on the Sanding Belt Support Plate (75).
7. Secure Work Stop in place using two
M5 x 10 Cap Screws and Washers (80).
Functions
Eye
Shield
LED
Lamp
Dust
Collection Port
Work Rest
Work
Stop
Work Rest
Support
Belt
Tension
Lever
Belt
Alignment
Knob
Sanding Belt
Wheel
Guard
Power
Switch
Grinding
Wheel
Belt
Cover
Guard Setup
1. Check that the Wheel Guard and
Wheel Guard Cover are in place.
2. Make sure the Spark Arrestor and Eye Shield
are installed and properly secured.
Dust Extraction Setup
1. Connect a 1‑1/4" ID hose from the Dust Collection Port to
a shop vacuum or dust collection system. A hose clamp
may be required. Hose, clamp and system not included.
2. Periodically check the Dust Collection
Port for sawdust buildup that would
reduce the dust collection efficiency.
Sanding Belt
Support Plate
M5x10
Cap Screws/
Washers
Work Stop
Dust
Collection
Port