Page 8 For technical questions, please call 1-800-444-3353. 70757
SAFETY OPERATION MAINTENANCESETUP
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Workpiece and Work Area Setup
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn the Power Switch of the appliance off and unplug the appliance from its
electrical outlet before performing any procedure in this section.
1. Designate a work area that is clean and well
lit. The work area must not allow access by
children or pets to prevent injury and distraction.
2. Route the power cord along a safe route to reach
the work area without creating a tripping hazard or
exposing the power cord to possible damage. The
power cord must reach the work area with enough
extra length to allow free movement while working.
3. Secure loose workpieces using a vise or clamps
(not included) to prevent movement while working.
4. There must not be hazardous objects such
as utility lines or foreign objects, nearby that
will present a hazard while working.
General Operating Instructions
1. If constructing a new system, connect 4″ vent
pipe (not included) to the 4″ Inlet (28).
2. Determine the size of the dust ports on your
tools and run vacuum hoses (not included) from
each tool to an appropriate sized adapter (not
included), and into the 4″ vent pipe (not included).
WARNING! TO PREVENT SERIOUS INJURY:
Do not tamper with or remove the grounding
pole on the plug. You must use this unit with a 3
pole receptacle. If you use an extension cord, it
must meet amperage specified (see Table A on
page 4), and the cord must be 3‑pronged.
3. Switch on the unit using the push button Switch.
4. During operation, periodically check
how full Collection Bag (30) is. Do
not let it fill more than 3/4 full.
5. When removing Collection Bag, wear
ANSI‑approved safety goggles, and a dust mask.
Shut unit off using the push button switch, remove
Bag Retainer (31) and empty Collection Bag.
Reinstall Collection Bag and Bag Retainer.
6. To prevent accidents, turn off the tool and
disconnect its power supply after use. Clean, then
store the tool indoors out of children’s reach.
TM
To Next Page
Loading...