What to do if my Bauer POSEIDON PE 250-TE's control system does not switch off?
If the control system of your Bauer Air Compressor does not switch off and the final pressure safety valve blows, it could be because the final pressure monitor is set too high or the final pressure safety valve is defective. Rectify the setting and replace the safety valve.
What to do if only a small amount of air comes out during function check of my Bauer Air Compressor?
If only a small amount of air or condensate comes out during the function check of your Bauer Air Compressor, it could be due to a contaminated condensate valve or sieve insert. Dismantle the condensate valve, remove the sieve insert, and clean or replace the components.
Why does the on-site residual current device (RCD) respond with my Bauer Air Compressor?
If the on-site residual current device (RCD) responds when using your Bauer Air Compressor, it could be because the residual current device is unsuitable. Use an all-current sensitive RCD (type B).
General| Power | 7.5 kW |
|---|---|
| Horsepower | 10 HP |
| Flow Rate | 250 L/min |
| Voltage | 400 V |
| Drive | Belt Drive |
| Dimensions | 110 x 75 x 100 cm |
| Phase | Three-phase |
Defines intended usage and outlines consequences of improper use and deviations from operating conditions.
Covers fundamental safety, electrical, pneumatic dangers, gas, dust, smoke, noise, and handling of substances.
Provides guidance on behavior in case of faults and emergencies, including fault rectification procedures.
Explains the unit's structure, function schematic, and operational principles like intake, compression, and cooling.
Provides performance characteristics, ambient conditions, weights, and auxiliary materials for various compressor models.
Covers checking cargo, preparing the machine, and safe transport methods, including warnings.
Ensures the installation site meets ambient conditions, stability, and space requirements.
Provides safety warnings and steps for installing the compressor unit, including outdoor placement.
Outlines critical safety precautions and procedures for connecting the unit electrically.
Covers pre-commissioning checks, initial setup, and motor rotation verification.
Addresses common faults in drive motor, compressor block, condensate drain, electrical systems, and B-TIMER errors.
To Next Page
