11
Setting and using the oven programmer/timer
Selecting manual operation mode
After your appliance is connected to your mains supply for the
first time, the numbers on the timer display will flash. Before
you can select a cooking function or set a temperature, you
must set the appliance into “manual operation” mode.
o To select manual operation mode, press the “manual operation”
button (9) on the control panel.
Setting the time of day
After setting your oven for manual operation, you should also
set the time of day.
o Use the “minus” button (10) and “plus” button (11) to adjust
the time that appears in the display. After getting the display to
the correct time, release the “minus” and “plus” buttons. After
five seconds the time will fix in the display and you will be able
to use your oven.
o The “manual operation” symbol (14) will light on the oven
programmer/timer display.
Before first use
o To remove any residue from the oven that may have been left
from the manufacturing process, you should select either the fan
or conventional oven function and turn the thermostat dial to its
maximum temperature setting.
o It is perfectly normal for a smell to be produced during this
process.
o You should make sure that any windows in the room are left
open during this process.
o It is advisable for you not to remain in the room whilst the
burning off process is taking place.
o You should leave the oven on maximum setting for 30 – 40
minutes.
To Next Page
Loading...
