Before first use
o To remove any residue from the oven that may have been left
from the manufacturing process, you should select the gas oven
and set it to its maximum temperature setting.
o It is perfectly normal for a smell to be produced during this
process.
o You should make sure that any windows in the room are left
open during this process.
o It is advisable for you not to remain in the room whilst the
burning off process is taking place.
o You should leave the oven on maximum setting for 30 – 40
minutes.
Setting the time of day (B609.1SS only)
When the oven is switched on for the first time (or if power has been
cut to the appliance), three zeros will flash on the timer display.
o To set the time of day, hold down button (A) and then press the
(B) and (C) buttons until the current time of day is shown on
the timer display.
o The speed that the time adjusts at depends on how hard the (B)
and (C) buttons are held down.
o When the correct time of day is shown, release all of the
buttons. After a few seconds the time of day will be set on the
timer display.
12
To Next Page
Loading...
