9
USING THE GRILL
To ignite the Grill Burner (GRILL MODE)
Caution: Accessible parts may be hot when the grill is used,
young children should be kept away.
1. The door must be in the fully open position. The solenoid is
active.
2. Put the heat shield.
3. Turn the control knob anti-clockwise
to the position (max). A
clicking sound will be heard and the grill burner will ignite.
4. Keep the switch pressed in for a further 10-15 seconds to activate
the Safety Device incorporated in the appliance. (The appliance
will not stay alight until the Safety Device has been activated).
5. Release the switch slowly and check that the burners are still
alight.
NOTE: Once ignition occurs, the cooling fan will automatically
come into operation.
There are two knob positions that allow flame regulation:
= max = min
WARNING
The door must always be open and the heat
shield fitted when the GRILL MODE is
used.
The grill output has a low and maximum
setting.
Variation for cooking purposes can be
achieved by moving the grill pan up or down.
If the cooling fan fails to start or operate
during cooking or grilling, turn the
Thermostat Selector back to the OFF
position and call the Service. Do not use the
appliance without the cooling fan in
operation. In any case there is a safety
thermostat which, when it is necessary, cut
gas supply off.
NOTE: Care should be taken when
removing the heat shield as it could be hot.
To Next Page
Loading...
