Selecting a wash program
9 Load your laundry and put detergent in the relevant
compartment of the soap drawer.
9 Close the porthole door firmly.
9 Activate the pop out
program selector knob by
depressing it.
18
9 Select the most
appropriate wash program
for the garments that you
are washing, by turning the
program selector knob.
o The LCD display will briefly flash the wash program number that
you have selected and then show the approximate time that it
will take the chosen wash cycle to complete.
9 Select any program options by using the program option button
underneath the LCD display (for more information, please refer
to the “setting a program option” section).
o Any program option that you select, will affect the length of time
that the wash cycle will take to complete. The LCD display will
update to reflect this change.
9 Press the Start/Stop button.
o After approximately 5 seconds, you will hear your washing
machine start the wash cycle.
o If there is a power failure or the plug is pulled out of the
socket when a wash cycle is in progress. Once power has
been restored, the wash program will continue.
o Whilst the wash program is
in progress, the program
phase and time remaining to
the end of the wash cycle will
appear on the display.
To Next Page
Loading...
