Replacing the oven bulb
IMPORTANT: The oven must be disconnected from
your mains supply before you attempt to either
remove or replace the oven bulb.
o Remove all oven shelves and drip trays.
o Remove the light cover by removing the 4
screws located in the corners of the glass
cover.
o Place the glass cover gently on a supported surface, so that
damage is not caused to it whilst the bulb is being replaced.
o Unscrew the bulb and remove it from its holder.
o Replace the bulb with a 25 W/300°C, E14 screw type pygmy.
o Do not use any other type of bulb.
o Place the lamp cover back into position and fully tighten the 4
screws that were removed previously.
o Replace the side rack, drip trays and oven shelves.
o Restore power to the appliance.
33
To Next Page
Loading...
