Control panel
1) ON/OFF button
2) ON/OFF indicator neon
3) Rinse aid and salt indicator neons
4) Program indicator neons
5) Program selection button
Using your dishwasher
Before first use
o Install the appliance as per the installation instructions contained
within this booklet.
o Fill the water softener with 1 litre of tap water and then fill with
specialist dishwasher salt. After this you should set the water
softener level.
o Fill the rinse aid dispenser and then set the rinse aid dosage.
Filling with dishwasher salt
IMPORTANT: You should only use salt that is specially
designed for use in a dishwasher. If any other type of
salt is used in the appliance (in particular table salt),
it will damage the water softener.
o Ideally you should fill the water softener with salt, just before
you are about to run a wash program. This will help to clear any
salt that may have overflowed from the water softener during
the salt filling process.
To Next Page
Loading...
