5. Place the main and coarse filter back into their original positions
in the base of the dishwasher. You must turn the coarse filter
clockwise to lock it back into position.
IMPORTANT: If a glass gets smashed inside of the appliance,
you must check there is no glass in the filter before the
machine is used again as this can cause a drainage failure.
IMPORTANT: THE DISHWASHER SHOULD NEVER BE
SET ON A WASH CYCLE WITHOUT THE FILTERS BEING
INSIDE OF THE APPLIANCE.
Cleaning the spray arms
The spray arms should be cleaned regularly, to prevent hard water
deposits from clogging the spray arm jets and bearings.
o To remove the spray arm, unscrew the nut and take out the
washer that sits on top of the spray arm.
o Gently pull upwards to remove the spray arm.
o Wash the spray arm in warm, soapy water and use a soft brush
to clean the jets.
o Rinse the spray arm thoroughly and then reassemble the spray
arm back in its original position.
To Next Page
Loading...
