Cleaning the spray arms
The spray arms should be cleaned regularly, to prevent hard water
deposits from clogging the spray arm jets and bearings.
o To remove the spray arm, unscrew the nut and take out the
washer that sits on top of the spray arm.
o Gently pull upwards to remove the spray arm.
o Wash the spray arm in warm, soapy water and use a soft brush
to clean the jets.
o Rinse the spray arm thoroughly and then reassemble the spray
arm back in its original position.
Cleaning the control panel
IMPORTANT: Do not use any abrasive cleaner or household polish on
either the control panel or operating parts.
o Wipe over the control panel using a brand new damp cloth with
warm water.
25
To Next Page
Loading...
