40
ecuring the dishwasher
be secured to the worktop, this can be
done in one of two ways:-
- Secure the dishwasher to the
underside of the worktop by using two wood screws.
t the
top of the dishwasher cabinet.
htened.
ial of the worktop
will mean that it is impossible to put a screw through the
ge of the dishwasher cabinet,
there is a rubber stopper. You should remove the rubber
shwasher to the cupboard either side of it, by
screwing a wood screw through the pre-drilled holes into
eir
original position.
Before fi
the following before using the appliance for the first
me:-
hat the dishwasher is level and fixed in position.
o That the water tap is fully open.
r inlet hoses.
fully tightened.
litre of water and
S
o The dishwasher must
o Standard worktop
o You should screw through the holes in the brackets a
o These screws should be fully tig
o Marble/granite worktop- The mater
underneath of the worktop.
o On either side of the front ed
stoppers, to reveal a pre-drilled hole on either side of the
dishwasher.
o Secure the di
the cupboards. These screws should be fully tightened.
o The rubber stoppers should then be refitted into th
rst use
You should check
ti
o T
o That there are no leaks at either end of the drain o
o That the inlet and outlet hose are
o That the inlet and outlet hoses are not kinked.
o That the power is switched on.
o That the water softener has been filled with 1
salt.
o That the rinse aid dispenser has been filled.
To Next Page
Loading...
