The upper rack has side flaps. There are 4 (2 on each side). These can be adjusted into 2 positions - high and low. To
move the flaps between these positions, find the large hinges clasping each flap to the upper rack. There are two of
these at either end of each flap. Gently pull both clasps off the wire rack and move the flap to the desired position.
Position 1
The upper position will accommodate items such as glass tumblers (placed beneath flap) and wine glasses. Wine
glasses can be placed upside down so that the neck nestles snugly in the grooves at the side of the flap with the base
of the glass facing upward.
Position 2
When flaps are move to the lower position, they can be used to hold additional tumblers, cups and mugs. Always
check that you are only placing items on the flaps that will clear the ceiling height of your dishwasher when you push
the rack back in. Be particularly careful with long-stemmed glassware such as champagne flutes.
How to load the lower rack:
Place large items that are hard to clean in the lower rack e.g. pots, pans, lids, serving dishes, bowls.
1. Oval platter
2. Dessert dishes
3. Soup plates
4. Dinner plates
5. Cutlery
• Pots, serving bowls, etc must always be placed upside down.
• Deep pots should be slanted to let water flow out.
• The bottom rack features fold down baskets so that larger or more pots and pans can be loaded.
Cutlery basket
Cutlery should be placed in the cutlery basket with handles always
pointing downward (at the bottom). Very long utensils (ladles etc)
should be placed horizontally at the front of the upper rack.
1. Forks 5. Knives
2. Soup spoons 6. Serving spoons
To Next Page
Loading...
Need help?
General
Weight and Dimensions
