Witheachwashcycle.
Compartment
For programmes with pre-wash only.
(Follow the user instructions!)
Electric indicator on control panel (if pro vided).
Check the rinse aid level
Load the baskets
Select a programme
Runni ng the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 mi n utes) before unloading the dishwasher to avoid handling
the dishes and utensils while they are still hot and more susceptible to break.
The y will also dry better.Unload the appliance, starting fro m the lower basket.
Changing t he programme
Add forgotten dishes in the
dishwasher .
Scrape off any large amount of leftover food. Soften remnants of burnt foo d in pans,
then l oad the baskets. Refer to the dishwashe r loadin g instructions.
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On /Off Button.
If the appliance is switched
off during a wash cycle.
Op en t he door caref ul l y.
Hot st eam may escape
when the doorisopened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance
For detailed operating method read the corresponding content on the instruction manual.
Close the door, t urn on the water tap. The machine will start working
after about 10 seconds.
Press the Prog ramm e Button, the selected programme indicator lights up.
( See the section entitled Opera ting in struction )“”
Open the door, press the On/Off button to switch on the appliance.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Ope n the door
, press the program button for more than 3 seconds, the machine will be in
s
tandby state, then you can change the program to the desired cycle setting.
1.Open the door a little to stop the washing.
2.After the spray arm s stop working, you can open the door
completely.
3.Add forgotten dish e s.
4.Close the door , the dishwasher will run after 10 secon ds.
To Next Page
Loading...
Need help?
General
