30
Cleaning the spray arms
The spray arms should be cleaned regularly, to prevent hard water
deposits from clogging the spray arm jets and bearings.
o To remove the upper spray arm, hold the nut and rotate the arm
clockwise to remove it.
o To remove the lower spray arm, gently pull it upwards.
o Wash the spray arms in warm, soapy water and use a soft brush
to clean the jets.
o Rinse the spray arms thoroughly and then reassemble the spray
arms back in their original positions.
Cleaning the control panel
IMPORTANT: Do not use any abrasive cleaner or household polish on
either the control panel or operating parts.
o Wipe over the control panel using a brand new damp cloth with
warm water.
To Next Page
Loading...
