CODE MEANING POSSIBLE CAUSES
E4 Temperature sensor Temperature sensor malfunction
E5 Overflow / leakage Overflow / water leakage occurs
E6 Water leakage Water leakage occurs
E7 Heating element Abnormal heating
IF THE FAULT CODE REAPPEARS AFTER FOLLOWING
THE ABOVE ADVICE AND CLEARING THE FAULT
CODE. YOU SHOULD TURN OFF THE APPLIANCE;
DISCONNECT THE APPLIANCE FROM YOUR MAINS
SUPPLY. THEN ARRANGE FOR AN ENGINEER TO
ATTEND THE APPLIANCE. YOU SHOULD CONTACT
THE CUSTOMER CARE DEPARTMENT ON TELEPHONE
NUMBER (0118) 933 6911.
IF AN ENGINEER ATTENDS DURING THE GUARANTEE
PERIOD AND FINDS THAT A FAULT HAS BEEN
CAUSED BY AN ITEM ON THE ERROR CODE LIST,
WHICH COULD HAVE BEEN CLEARED BY THE
CUSTOMER. THEN YOU MAY BE LIABLE FOR THE
COST OF THE SERVICE CALL.
General troubleshooting
PROBLEM POSSIBLE
CAUSES
WHAT TO DO
Dishwasher
doesn’t
run
Fuse blown or the circuit
breaker has
tripped
Power supply is not switched
on
Water pressure is low
Replace the fuse or reset the circuit breaker.
Remove any other appliances that are sharing
the same circuit with the dishwasher.
Make sure that the dishwasher is turned on and
that the door is closed securely.
Make sure that the power cord is fully plugged
into the wall socket.
Check that the water supply is connected
properly and that the water is turned on.
Drain pump
doesn’t
stop
Overflow The system is designed to detect an overflow. If
it does, then it will run the drain pump
continuously when there is power to the
appliance.
Noise Some audible sounds are
normal
Utensils are not secure in the
baskets or something small has
dropped into the basket
You will get a level of operating noise during a
wash cycle, in particular when food is being
removed from items and when the detergent
dispenser places the tablet into the tub.
Ensure that everything is loaded as per
Baumatic’s loading instructions.
28
To Next Page
Loading...
