o The “green-yellow” earth wire must be connected to the terminal
marked . It must be about 10 mm longer than the live and
neutral wires.
o The “blue” neutral wire must be connected to the terminal
marked with letter (N) - the live wire must be connected to the
terminal marked with letter (L).
My appliance isn’t working correctly
o The cooking zones are not functioning or will not switch
on.
* It has been more than 10 seconds since the appliance was
switched on. You should switch the appliance on again, using the
ON/OFF button.
* The safety lock has been switched on (see the “Locking the hob
top” section for information on how to turn off the safety lock).
* Several cooking zone selection buttons have been pressed at
once. You should only touch one cooking zone selection button at
once.
* The safety cut out has been triggered. Press the ON/OFF button
(1) to reset the appliance.
* Check that the mains electrical supply to the appliance is correct
and working. Check the mains fuse.
o The residual heat indicator has not come on after I have
switched a cooking zone off.
* The cooking zone has only been turned on for a short period of
time; therefore it did not go above 60°C.
* IMPORTANT: If the cooking zone does appear to be hotter than
60°C and the residual heat indicator has not come on, you
should call the Baumatic Service Department.
o A humming sound is heard when a cooking zone is
selected.
* This is normal; the sound will disappear when the zone heats up.
27
To Next Page
Loading...
