15
Residual heat indicator
o After a zone is switched off, the display will
show the letter “H”. This means that the
temperature of the indicated zone is still high
enough to cause injury.
o When the temperature falls to a safe temperature, then the
letter “H” will go out.
o The residual heat can also be used to continue heating pans on
the cooking zone that is still hot to save energy.
o IMPORTANT: The residual heat indicator will disappear if your
mains supply is cut.
Locking the hob top
o You can lock the control panel to prevent unintended use by
other persons such as children.
o When the safety lock is turned on, all the buttons except the
ON/OFF button (1) will be disabled.
o To turn the safety lock on, press the safety lock button (5). The
timer display will show “Lo” to indicate that the lock has been
activated.
o To unlock the controls you need to ensure that the hob is turned
on. Then, press and hold the safety lock button (5) for a few
seconds. The safety lock will then be deactivated.
Using the timer as a minute minder
It is possible to use the minute minder even if you do not turn on a
cooking zone.
o Turn the hob on by pressing the ON/OFF button (1).
o Press the timer button (4) and the minute
minder indicator will start flashing. “10” will
show in the timer display.
o Set the required countdown time using the plus
and minus buttons (2). The maximum time that
can be set is 99 minutes.
To Next Page
Loading...
