o Unscrew screw (A) which will allow you to remove the oven
burner.
o Unscrew the injector (B) and replace it with one suitable for LPG
(see the power inputs information on page 29). It is
recommended that the appropriate thread sealant is used;
always check for gas tightness after assembly.
o Re-fit the burner and the base of the oven cavity by following
the above steps in reverse.
o Remove the grill burner.
o Replace the injector with one
suitable for LPG (see the power
inputs information). It is
recommended that the
appropriate thread sealant is
used; always check for gas
tightness after assembly.
To Next Page
Loading...
