10
The installer must ensure that:
• The mains power voltage and frequency cor-
respond to what is marked on the identifica-
tion plate.
• The wiring system can withstand the maxi-
mum power marked on the identification
plate.
• After connecting the power, check that all
electrical parts of the oven are working cor-
rectly.
• Disconnection from the electrical supply
must be allowed after the oven is in the ins-
talled position.
For all ovens. after the power has been connec-
ted:
1 Position the oven inside the unit and en-sure
that the power cable is not trapped or in con-
tact with parts of the oven that heat up.
2 Anchor the oven to the unit with the screws
supplied, screwing them into the unit through
the holes that can be seen when the door is
open.
3 Make sure that the body of the oven is not in
contact with the walls of the unit and that
there is a separation of at least 2 mm with
the adjacent units.
Oven Installation
Electrical Connection
To Next Page
Loading...
