8
To mount the door, hold it with both hands and
insert the hinges in the appropriate openings in
the front of the oven. Slowly open the door until
it is fully open.
Instructions for Removing / Replacing Inner
Glass
1 Open the oven door.
2 Pull the glass outwards by the bottom (H).
Figure 10
3 The inside glass will become loose. Remove
it.
Caution
Be very careful when removing the inner glass,
as the oven door will close.
4 Clean the inner glass and the inner surface of
the oven door.
5 Return the glass supports to the upper door
slots (I). Figure 11
6 Turn the glass towards the door (K).
7 Attach the glass to the door again by push-ing
the two lower supports (L) with both hands
while pushing the glass towards the door (M).
Figure 12
Warning
If the door has not been blocked with the clamp
(N), please take care when removing the inside
glass panels as the oven door will close.
6 Once clean, return the glass panels in the
same order so that the word TERMOGLASS
can be read.
7 Replace the upper clasp of the door, making
sure that the side tabs fit in point 1.
Cleaning the Large Inner
Glass Door
Caution
First make sure the oven is unplugged before
proceeding to change the bulb.
Warning
Ensure that the appliance is switched off before
replacing the lamp to avoid the possibility of
electric shock.
• Unscrew the bulb-holder glass cover.
• Replace the bulb and reassemble the glass
cover.
The replacement bulb must be resistant to tem-
peratures up to 300ºC. You can order one from
the Technical Assistance Service. Figure 16
For other oven models, follow these instructions:
• Loosen the lens from the lampholder with the
help of the appropriate tool. Fig 17
• Exchange the bulb.
• Replace the lens, making sure it fits in the
correct position without forcing it. Fig 18
Changing the Oven Light bulb
To Next Page
Loading...
