This function can be used even when you are
already using the oven. To do this, follow the
instructions indicated above except point num-
ber 4.
Setting the Cooking Time and the End
Cooking Time
1 Press or until symbol lights up.
Press OK.
2 Select the period of time you wish to cook
for by pressing or .
3 The clock beeps twice, the current time is
displayed and symbol lights up perma-
nently.
4 Press or until symbol lights up.
Press OK.
5 Select the time you wish the cooking process
to finish at by pressing or .
6 The clock beeps twice, the current time is
displayed and symbol lights up perma-
nently.
7 Select a cooking function and temperature.
8 The oven remains off with symbols and
lit up. Your oven is set.
9 When the time to start cooking is reached,
the oven starts up and cooks for the set
period of time.
10 When the set end cooking time is reached,
the oven turns itself off, the alarm sounds
and symbols and flash.
11 Press any button to stop the alarm and turn
the oven back on again.
12 Set the controls to to turn the oven off.
You can modify the end cooking time by pressing
or until symbol lights up and then
pressing OK. You can now modify the end cook-
ing time by pressing or . The clock beeps
twice to confirm the change.
Child Safety Function
This function can be selected at any time while
using the oven.
To activate the function, press the + and – sen-
sors at the same time for several seconds. You
will hear a beep and the display will show the
word SAFE. The clock is locked.
If the oven is off and you activate the child
safety function, it will not work even if a cooking
function is selected.
If this function is activated while you are coo-
king, it will only lock the electronic clock set-
tings.
If a clock sensor is touched while the child safety
function is on, the word SAFE will appear on the
display. The clock is locked.
To disable the function, press the + and – sen-
sors at the same time for several seconds until
you hear a beep.
Important
In the event of a power cut, all the electronic
clock settings are deleted and the indication
00:00 flashes on the display. It is necessary to
set the time and programme the clock again.
14
To Next Page
Loading...
