Follow the instructions below to complete a
pyrolytic cleaning cycle:
IMPORTANT: Remove all accessories (trays,
grills, tray side supports, tele-
scopic guide rails) from inside the oven.
1. Ensure all major food residues are removed
from the oven and thoroughly clean the inner
door glass.
2. Turn the cooking control dial to the Pyrolytic
position . You will hear a beep which
confirms this function has been chosen.
3. You will then see a P (pyrolytic programme)
on the timer display together and the symbol
will flash.
4. Press the + or – sensors to select one of the
pyrolytic programmes (P1, P2 or P3).
P1: Minimum programme (lasts 1 hour).
P2: Standard programme (lasts 1.5 hours).
P3: Maximum programme (lasts 2 hours).
5. After a couple of seconds, you will hear 2
beeps confirming the pyrolytic programme
chosen.
6. After a short time, the pilot light will turn
on and the oven door will be locked.
7. The oven will start to heat up and the symbol
will appear permanently. The timer dis-
play will show the time remaining until the
end of the programme.
IMPORTANT: At this point, the oven is program-
med and the pyrolitic cleaning cycle is under-
way. During the cycle, none of the oven timer
functions may be chosen. Do not try to open the
oven door as this may interrupt the cleaning
process.
8. When the pyrolytic cleaning cycle has finis-
hed, an alarm will sound and the symbol
will flash.
9. Press any of the timer keys to turn the
alarm off. The symbol will disappear.
10. Turn the cooking control dial to the position
.
11. Although the oven’s heating process has
ended, it is extremely hot and cannot be
used. The cooling motor will operate until
the oven cools down and the pilot light
will remain on.
IMPORTANT
The cooling process may last up to 2 hours
because of the high temperatures inside the
oven.
12. Once pilot light has turned off, you will
soon be able to open the oven door.
IMPORTANT
To open the door (pilot light on), the control
dial must be in position . If you did not follow
step 10, set the control dial to position and
wait a few minutes until the door unlocks and
the pilot light turns off.
13. Open the oven door and wipe the inside
with a damp cloth, cleaning up the ash from
the cleaning cycle. Hard-to-reach areas in
the oven will need to be cleaned with a non-
metallic fibre scourer.
14. Once the oven is clean, remember to repla-
ce the supports and accessories.
15. The oven is now ready to be used.
IMPORTANT: If any incidents are detected in
the programming and operating of this func-
tion, consult the section “Incidents while
Operating the Pyrolytic Function”.
PROGRAMMING AND OPERATING THE PYROLYTIC FUNCTION
15
To Next Page
