CANCELLING THE PYROLYTIC CYCLE
Pyrolytic is an automatic function and therefore
can only be activated from the timer programme.
To cancel a cleaning cycle it is necessary to reset
the oven, following the instructions below:
1 Set the function control at and wait for 1
minute.
2 Unlock the oven door.
1 Set the function control at and wait for
1 minute. The oven will no longer heat up.
2 Unlock the oven door. To cancel the clean-
ing cycle, the oven door must be unlocked.
To do so, consider the following:
a) Unlocking the door 45 minutes after the
cleaning cycle. If the oven has been ope-
rating for more than 45 minutes, the door
will unlock automatically once the oven
has cooled down to the safe temperature.
Then, pilot light will switch off.
b) Unlocking the door in the first 45 min-
utes (at a low temperature). Within the
first 45 minutes the oven door will unlock
automatically. Follow the instructions
below:
1 Turn the control dial to position .
2 Wait for approximately 1 minute.
3 Turn the control dial to position .
4 Approximately, 1 minute later pilot
light will turn off and the oven door
can be opened.
16
To Next Page
Loading...
