SAFETY INSTRUCTIONS
Read these instructions carefully to obtain the best
performance from your oven. Keep this manual so that it
can be read by a new owner.
Electrical safety
• In order to connect the oven to the mains, the
technician should use an H05SS-F power cable. The
connection diagram is shown in Figure 12.
• The oven must always have a good earth connection in
line with current regulations.
• Total disconnection from the mains installation must be
incorporated when installing the oven, as specified in
the installation regulations, (suitable for the heat
intensity to be withstood and with a minimum space
between contacts of 3 mm) following category III
conditions for surges, for disconnection in case of
emergency, for cleaning or for changing the light bulb.
Under no circumstances should the earth wire pass
through this switch.
• This switch may be replaced by a plug, provided it is
accessible for normal use.
• If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
• Any handling or repair to the appliance, including
replacement of the power cable, should be carried out
by authorised Technical Service Personnel using
ENGLISH
3
To Next Page
Loading...
