22
Adjusting the height and levelling off your wine cabinet
o The appliance is equipped with adjustable feet, so that the
height may be adjusted to level the cabinet on uneven floor
surfaces.
o We recommend that two people carry out this procedure.
o The height must be adjusted prior to building the appliance into
the housing unit and it should be set at such a height that the
top panel of the appliance fits exactly below the kitchen worktop.
o Tilt the appliance approximately
60° to allow access to the
adjustable feet.
o Take care to ensure the cabinet
is supported at all times.
o Loosen the securing nut.
o Twist the foot into a suitable position to
level the cabinet.
o Tighten the securing nut to set the foot
into position.
o Repeat these steps for the other
adjustable feet.
IMPORTANT: If the appliance is not level, then the door and
door seal may be affected.
IMPORTANT: Do not move the appliance when the feet are
adjusted high.
To Next Page
Loading...
