o Remove the filter and
rinse out the filter under
the tap. Remove any
debris from the filter.
o Remove any debris that is in the area of the appliance that you
removed the drain pump filter from.
o Screw the filter clockwise back into position, making sure that it
is fully tightened. You should keep turning until you cannot turn
it any further.
o Shut the filter flap.
o IMPORTANT: Do not perform this operation if the
appliance has stuck on a cycle, until the water inside the
machine has cooled sufficiently. Otherwise the water that
comes out of the drain pump filter may still be hot.
Winter storage
o You should install your appliance in a location where it will not be
subjected to freezing temperatures.
o If you are going to store your appliance in a location where the
temperature will drop below freezing in winter, then you should
follow the table below.
24
To Next Page
Loading...
