EasyManua.ls Logo

Baumatic TITAN4 - Saving Energy; Cleaning and Maintenance

Baumatic TITAN4
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
o If you change the water filter before the FILTER CHANGE icon
comes on, then you should still press and hold the LIGHT
BUTTON for 5 seconds to reset the countdown.
Important user information
IMPORTANT: Care should be taken to make sure that
the airflow duct vents on the rear interior wall of the
fridge and freezer sections are not blocked.
IMPORTANT: If your mains power supply fails, then
the food inside of the freezer section will be
preserved for a 12 hour period. After 12 hours the
food should be removed from the freezer section and
consumed as quickly as possible.
IMPORTANT: If power is cut to the appliance, when
power is restored it will take approximately 30
minutes for the compressor to start running again.
Saving energy when using your fridge-freezer
Installing:
o Install the appliance in a cool position. If it is placed in direct
sunlight or next to an oven or other heat source, the energy
consumption can increase substantially.
o Ensure the appliance is installed with the correct ventilation
requirements. Restricting ventilation can increase the energy
consumption by 15%.
Cleaning and Maintenance:
o Occasionally clean the condenser coils (if present) at the back of
the appliance to maintain a high performance level.
o Clean the door gasket with warm water or a neutral detergent
that leaves no residue. A tight-sealing door gasket is critical to
the efficiency of your appliance.
Usage:
o Do not open the door repeatedly or more frequently than you
have to.
22

Table of Contents

Related product manuals