Connecting the water inlet hose and water filter
1) Connection the water inlet hose to the connector on the rear of the
appliance.
2) Place the seal inside of
connector A and then screw
connector A securely onto your
cold water mains supply. Push
the water inlet hose firmly onto
connector A.
o Ensure that the water tap which the inlet hose is connected to is
fully open.
o Select the water dispensing option and run it for 2 – 3 minutes,
this supplies water to the water tank and will eventually dispense
water.
IMPORTANT- The running of water through the inlet hose and filter
must be done, to make sure that any impurities from the
manufacturing process are washed out.
34
To Next Page
Loading...
