N 153
www.baumer.com 27
7. Technical data
Technical data – electrical ratings
Supply voltage 24 VDC ±10%
Power consumption <40 mA
Display LCD, 7 segment, 2 lines, backlit
Sensing principle Absolute multiturn sensing
Sensing range -99.99...+999.99 mm
-9.999...+99.999 inch
Number of steps/revolution 1440
Number of revolitions 4096 / 12 bit
Spindle pitch ≤14 mm
Interface RS485 (ASCI protocol)
Data saving Parameter buffer: EEPROM
Actual value buffer: >10 years by integrated 3 V Lithium battery
Programmable parameter Display position horizontal / vertical
Measuring unit mm/inch
Counting direction
Spindle pitch
Spindle tolerances
Positioning direction
Arrows
Tolerance window
Rounding function
Motive positioning Two softkeys with jog operation for format alignment
connected to power tool by infrared interface
Standard DIN EN 61010-1 Protection class II
Overvoltage category II
Pollution degree 2
Interference emission DIN EN 61000-6-3
Interference immunity DIN EN 61000-6-2
Approval UL/cUL
Technical data – mechanical design
Hollow shaft ø14 mm
Operating speed ≤600 rpm (short-term)
Protection DIN EN 60529 IP 65
Operating temperature -10...+50 °C
Storage temperature -20...+70 °C
Relative humidity 80 % not condensing
Torque support Torque pin provided at housing
E-connection - male/female 4-pin M8 connector
- cable output (30/ 5 cm) with male/female 4-pin M8 connector
User surface / keypad Keypad with two softkey
Housing With hollow shaft for direct shaft mount
Dimensions W x H x L 37 x 75 x 45 mm
Mounting Hollow shaft mount
Weight approx. 120 g
Material Polyamide black, UL 94V-0
To Next Page
Loading...
