Page 4
IP Series Codec Installation and Operating Instructions
PRODUCT SAFETY
Please follow these instructions as you install your IP Series Codec and retain them for its lifetime. If you encounter any
problems contact your agent.
Installation is only to be carried out by competent, qualified and experienced personnel. Wire in accordance with
the National Wiring regulations applicable to the country of installation. Failure to do so can result in death or
injury by electric shock. A means of disconnecting the equipment from the mains supply must be provided as part
of the installation and must be situated close by.
BEFORE UNDERTAKING ANY INSTALLATION OR MAINTENANCE, THE MAINS SUPPLY MUST BE DISCONNECTED.
Each internal printed circuit board carries a replaceable fuse. For continued protection against the risk of fire,
replace with a fuse of the same type - 1.5 A (T) 125V.
The equipment supplied with this manual is designed for use in a general purpose CCTV installation and has no other
function. Do not exceed the voltage and temperature limits given in the specifications. Only use your IP Series Codec in a
clean, dry, dust-free environment unless a suitable protective housing is provided.
Electrical Safety
British Standard BSEN60950:2000 Safety of information technology equipment, including electrical business equipment.
ELECTROMAGNETIC COMPATIBILITY (EMC)
Radio Frequency Emmissions
Federal Communications Commission Code of federal regulations part 15.
British Standard BSEN55022:1998 Limits and methods of measurement of radio disturbance characteristics of information
technology equipment.
This is a Class A product. In a domestic environment this product may cause radio interference in which case the
user may be required to take adequate measures.
Immunity
British Standard BSEN50130-4 Alarm Systems Part 4 Electromagnetic compatibility Product family standard: Immunity
requirements for components of fire, intruder and social alarm systems.
MANUFACTURERS DECLARATION OF CONFORMANCE
A Declaration of Conformity in accordance with the above EU standards has been made and is on file at Baxall Limited,
Stockport SK6 2SU, England.
The manufacturer declares that the product supplied with this document is compliant with the provisions of the EMC
Directive 89/336 and associated amendments, and the Low Voltage Directive LVD 73/23 EEC.
UNPACKING
Keep your packaging for use if the product is to be stored for an extended period or needs to be returned for any reason.
The packaging should contain:
IP Series Codec
Mains cable
19 rack mounting brackets and screws
These Instructions
Check the product code on the serial number label. If you have an incorrect item or it is damaged then inform the suppliers
and carriers immediately. If this is the case then do not attempt to use the equipment.
To Next Page