To Next PageTo Next Page
Need help?Do you have a question about the Baxi Solo HE and is the answer not in the manual?
General| Model | Solo HE |
|---|---|
| Fuel Type | Natural Gas |
| Efficiency Rating | A |
| Mounting | Wall Mounted |
| Warranty | 2 Years |
| Central Heating Flow Temperature Range | 30 - 80 °C |
| Flue Options | Horizontal/Vertical |
| Output Rating | 24kW |
| Output | 24kW |
Explains notification via Competent Persons Schemes and the role of the Benchmark Checklist.
Covers GB and IE requirements, including Gas Safety and Building Regulations.
Details the Baxi Solo HE A range, outputs, gas type, and system compatibility.
Illustrates the step-by-step process of the boiler's operation.
Details conditions for open vent and sealed water circulating systems.
Details requirements for zone controls, timers, and boiler interlocks for compliance.
Covers safety valve, pressure gauge, expansion vessel, and filling point requirements.
Specifies pipe material, diameter, fall, support, and length for condensate drains.
Details how to install the kit to manage condensate plume nuisance.
Details marking and cutting holes for the wall plate and flue.
Guides on how to mount the boiler onto the prepared wall plate.
Details how to connect water pipes and the condensate drain.
Step-by-step guide for installing the horizontal flue system.
Details how to connect incoming electrical cables to the terminal block.
Outlines the essential steps for commissioning the boiler, including system checks.
Details how to check the working gas inlet pressure at maximum load.
Explains how to measure the gas rate with other appliances turned off.
Recommends annual servicing by a competent person and lists checks.
Specifies how to check CO/CO2 ratio and the required competence for analysis.
Emphasizes isolating supplies and checking component seals before servicing.
Details visual checks and cleaning of parts like the burner, heat exchanger, and seals.
Stresses isolating gas and electrical supplies before changing parts.
