Need help?Do you have a question about the Baxi Solo 15 HE and is the answer not in the manual?
General| Mounting | Wall |
|---|---|
| Output | 15 kW |
| Fuel Type | Gas |
| Dimensions (H x W x D) | 700 x 400 x 300 mm |
| Fuel | Gas |
| Operating Pressure | 1.0 bar |
| Boiler Type | Wall-mounted |
Details on Building Regulations, CORGI schemes, and Benchmark Logbook status.
Guidance on notification routes via Competent Person or Building Control.
Requirements for installation, commissioning, service, repair, and relevant codes.
General handling advice, preparation, technique, and safety reminders.
Overview of the Baxi Solo HE range, product description, and important information.
Identification of boiler components and layout diagrams.
Detailed steps of the boiler's operational sequence.
Specifications, ratings, dimensions, clearances, and hydraulic data.
Detailed dimensions and side flue installation clearances.
Guidelines for open vent and sealed water systems and their treatment.
Pipework specifications, low head installation, and pump fitting.
System control configurations and requirements for sealed systems.
Guidelines for boiler location, including ventilation and compartment siting.
Instructions for correctly installing the condensate discharge pipework.
Requirements for flue installation, terminal positioning, and clearances.
Details on installing horizontal flue systems, including lengths and bends.
Details on installing twin and vertical flue systems.
List and description of available flue accessories and kits.
Specific installation guidance for vertical, twin, and roof flue systems.
Information on flue dimensions, terminal guards, and plume deflectors.
Details on the Plume Displacement Kit and its purpose.
Guidance on determining permissible flue lengths using the P.D.K.
General fitting instructions for the Plume Displacement Kit.
Steps for initial preparation, including wall plate installation.
Procedure for unpacking and preparing the boiler for installation.
Instructions for fitting the boiler and making water/drain connections.
Guidance on making gas, flue, and electrical connections.
Specific instructions for vertical flueing.
Steps for making the necessary electrical connections.
Diagram showing the electrical connections and components.
Visual representation of the boiler's electrical wiring.
Step-by-step guide for commissioning the boiler.
Instructions for fitting the outer case and handover to the user.
Procedure for performing annual servicing on the boiler.
General precautions before changing any boiler components.
Procedure for replacing flow temperature thermistors and safety thermostats.
Instructions for replacing the flow switch.
Procedure for replacing the main PCB.
Instructions for replacing spark and sensing electrodes.
Procedure for replacing the fan assembly.
Instructions for replacing the injector pipe.
Procedure for replacing the gas valve.
Instructions for replacing the condensate trap.
Procedure for replacing the burner assembly.
Instructions for replacing the heat exchanger.
Procedure for replacing heat exchanger insulation pads.
List of key boiler components with part numbers.
Introduction to fault finding and interpretation of LED status.
Diagnostic steps for faults related to electrical supply.
Diagnostic steps for dry-fire faults.
Diagnostic steps for ignition lockout faults.
Diagnostic steps for overheat lockout faults.
Diagnostic steps for fan lockout faults.
Diagnostic steps for thermistor faults.
Checklist for confirming installation and commissioning compliance.
Log for recording regular servicing and maintenance history.
To Next Page