AdC
As the A/D change overflowing, display shows this with the ding sounding.
-BatLo-
The voltage is lower. You can use a short while and chage immediately.
C End
Recharge is end.
Err-0
Loadcell bad connected or A/D error
Err-1
Calibration switch placed at OFF during calibration
Err-2
No enough sample (on piece counting mode)
Err-3
Calibration weigh too small
3. OPERATION GUIDE
3.1. PREPARATION:
Adjust the base foot, watch the level, make the pan in horitzontal.
3.2. TURN ON OR TURN OFF:
3.2.1 TURN ON
Press the key, the ding sound, it displays version No. and the battery voltage level and 9, 8, 7, ..., 1, 0, the “→ 0 ←”. led lighting.
Now the scale is in a working state.
3.2.2 TURN OFF
Long-press key.
3.2.3 AUTO-OFF:
After 10 minutes in zero, scale will auto-off.
3.2.4 LOW VOLTAGE AUTO-OFF
When the voltage lower than 5.6V, then power-off.
3.3. ZERO:
When without taring the weight display is ≤ 4% Max. capa., press the key, the display shows “0 ”, the → 0 ← led lighting.
3.4. WEIGHING:
Put weight to pan.
3.5. TARE WEIGHT:
Press the key, the weight display is “0 ”, the → 0 ← led off, the → T ← led lighting. Pick up the weight, the weight display is negati-
ve, the → 0 ← lighting, press the key, the → T ← led off.
3.6. FUNCIÓN AHORRO DE ENERGÍA
Zero after 40 seconds, auto save power, shows “O ”.
Put a weight start weighing.
3.7. BATTERY INDICATE
Battery led: means voltage higher than 6.3V, means voltage between 6V and 6.3V; and means voltage lower than 6V.
3.8. CHARGE
Power supplied by a internal rechargeable lead acid battery (6V/4Ah). When it shows “-bAtLo-”. Please turn off and charge immedia-
tely. The time of full charging is 12 - 14 hours.
To Next Page
Loading...
