Troubleshooting (contd)
To perform a factory reset, turn on your speaker and wait for the RED light to stop ashing (indicating it has completed its
initialisation)
At the rear of the speaker, locate the button labelled ‘WIFI MODE’. Press and hold this button for seconds, then let go.
The RED light at the front will ash as the speaker restarts.
Once the RED light has stopped ashing, your speaker has been factory reset and is ready for network conguration –
see the Quick Start section of this user guide.
Specications
System Requirements
• To use StreamQ App requires: iOS or higher, Android . KitKat or higher
• For HD Audio requires (minimum): G Wireless N WiFi or Base T Ethernet network
• For streaming from online music services requires: internet connection (bre broadband recommended)
• Recommended: Dual band Wireless AC router with MB RAM
• Power – requires - V AC /Hz mains connection
To Next Page
Loading...
