BayTech ATS Series - Change Buzzer Audible Alarms

Page17
Change Buzzer Audible Alarms
1)...Powerlossbuzzeralarm:Off Defaultoff
2)...Overcurrentbuzzeralarm:On DefaultOn
EnterRequest:1
EnterRequest:2
Disableovercurrentbuzzeralarm(Y/N)?
EnterRequest:1
Enablepowerlossbuzzeralarm(Y/N)?
Select 9), from the configure menu to allow the user to turn off the Alarm for a Power Loss and
Over-Current Alarm. Power Loss Buzzer Alarm Default is Disabled. Over-Current Buzzer
Alarm Default is Enabled.
If the Power Loss Buzzer Alarm is set to OFF, Type ‘1’ and press Enter. The unit will display (Y/N)
option. Type ‘Y’ and press Enter to enable the Power Loss Buzzer. Type ‘N’ and press Enter to
maintain current state.
If the Over Current Buzzer Alarm is set to ‘ON’ and we wish to turn off the Alarm, Type ‘2’ and
press Enter. The unit will display (Y/N) option. Type ‘Y’ and press Enter to disable the Over-Current
Buzzer. Type ‘N’ and press Enter to maintain current alarm state.
1)...Powerlossbuzzeralarm:Off Defaultoff
2)...Overcurrentbuzzeralarm:On DefaultOn
EnterRequest:2
Press Enter. The unit will display (Y/N) option. Type ‘Y’ and press Enter to disable the Over-Current
Buzzer. Type ‘N’ and press Enter to enable the buzzer.
If the Over-Current Buzzer Alarm is set to ‘OFF’ and we wish to turn on the Alarm, Type ‘2’ and
press Enter. The unit will display (Y/N) option. Type ‘Y’ and press Enter to enable the Over-Current
Buzzer. Type ‘N’ and press Enter to maintain current alarm state.
EnterRequest:2
Enableovercurrentbuzzeralarm(Y/N)?
If the Power Loss Buzzer Alarm is set to ON, Type ‘1’ and press Enter. The unit will display (Y/N)
option. Type ‘Y’ and press Enter to enable the Power Loss Buzzer. Type ‘N’ and press Enter to
maintain current state.
EnterRequest:1
Disablepowerlossbuzzeralarm(Y/N)?