Bazooka CS8A5 - Page 5

3. Place each
mounting base
under the Bazooka
so that the apex at
the bottom of the
tube sits inside the
mounting base as
in figure7.
4. Move the bases
so that they are
spaced approxi-
mately 3” from
each end of the
enclosure as illus-
trated in figure 8.
5. Remove the
Bazooka without
moving the mount-
ing bases and set it
aside.
6. Screw each
mounting base
securely in place
with screws provid-
ed as illustrated in
figure 6.
MOUNTING THE BAZOOKA
7
Figure 7
Figure 8
3
,,
3
,,
Figure 10
Figure 9
MOUNTING THE BAZOOKA
8
7. Adjust buckle end
of strap so that it
extends out of the
mounting base 22”
(see figure 9) the
proper length for
the model size of
Bazooka you are
installing.
8. Remove any slack
in the strap by feed-
ing it out of the
mounting base on
the loose end of the
strap opposite the
buckle.
9. Place Bazooka on
the mounting bases
and fasten the buck-
les as illustrated in
figure 10. The strap
should loop through
the buckle and be
tightened securely
by holding the strap
in place with one
hand and pulling
the loose end away
from the buckle, but
against the cabinet.
Technical Note
Due to the jarring and shifting that can occur in a vehicle, the mount-
ing straps may stretch or loosen. We recommend that you check the
straps regularly to assure that your Bazooka is mounted securely in
place.
22”