GSF2616 owner’s manual
27
Obstruction of gas flow. Clear burner tubes.
Check for bent or kinked hose.
Disengagement of burner to valve. Reengage burner and valve.
Spider webs or insect nest in Clean venturi.
venturi.
Burner ports clogged or blocked. Clean burner ports.
Sudden drop in gas flow Out of gas. Check for gas in propane tank.
or reduced flame height.
Excess flow safety device may Turn off knobs, wait 30 seconds and
have been activated. light grill. If flames are still too low. Reset the excessive flow safety device by turning off knobs and propane tank
valve. Disconnect regulator. Turn burner control knobs to HIGH. Wait 1 minute. Turn burner control knobs off.
Reconnect regulator and leak check connections. Turn propane tank valve on slowly, wait 30 seconds and then
light grill.
Irregular flame pattern, Burner ports are clogged or Clean burner ports.
flame does not run the full blocked
length of burner.
Flame is yellow or orange. New burner may have residual Burn grill for 15 minutes with the lid closed.
Manufacturing oils.
Spider webs or insect nest in venturi. Clean venturi.
Food residue, grease or seasoning Clean burner.
Salt on burner.
Poor alignment of valve to burner Assure burner venturi is
venturi. properly engaged with valve.
Flame blow out High or gusting winds Turn front of grill to face wind
or increase flame height.
Low on propane gas. Replace or refill propane tank.
Excess flow valve tripped Refer to “Sudden drop in gas flow or reduced flame height.
Flare-up Grease buildup. Clean grill.
Excessive fat in meat. Trim fat from meat before grilling.
Excessive cooking temperature. Adjust (lower) temperature accordingly.
To Next Page
Loading...
