BBQ SSS3416TCS - Assembly Instructions

SSS3416TCS
Owner’s Manual
7
Assembly Instructions
Remove all contents from the carton packaging. Make sure all parts are present before attempting assembly. Once the grill is
fully assembled, go back and check to make certain all the bolts are secure. Tighten again
using the screwdriver provided if
necessary.
Estimated assembly
time: 30 minutes.
AA
M6 x 15 Bolt 2 PCS
BB
Spring washer 2 PCS
CC
Flat washer 2 PCS
Step 1 ( C art side panel assembly )
Note: Before beginning assembly, make certain the two
swivel casters on the cart base (Q) are locked.
a) Loosen the six pre-installed bolts on the cart base (Q)
and allow 1/4 bolt’s length to extend from the cart base
(Q).
b) Align the holes upon the left side of cart base (Q) with
the holes on the cart left side panel (K) and tighten the
pre-installed bolts by hand.
c) Repeat the procedure with the cart right side panel (S)
on the upper right side of cart base (Q).
d) Go back and tighten all bolts using the screwdriver
p
rovided.
Step 2 (C art back panel assembly )
a) Loosen the four pre-installed bolts on the cart back panel (N)
and allow 1/4 bolt’s length to extend from the cart back panel
(N).
b) Align the holes on cart left side panel (K) with the holes on the
cart back panel (N).
c) Insert one M6 x 15 bolt (AA), spring washer (BB) and flat washer
(CC) into each pre-drilled holes and tighten the bolt s by hand.
d) Repeat the procedure with cart right side panel (S) and cart back
panel (N).
e) Go back and tighten all bolts using the screwdriver provided.